European product compliance is entering a period of significant change, with manufacturers facing a major machinery legislation deadline in January 2027, further updates to harmonised standards and early discussions about the future of digital CE marking.
For manufacturers, importers and engineering businesses selling into the European market, October is an important time to review compliance strategies and prepare for the next phase of EU product legislation.
Machinery Regulation: January 2027 Deadline Draws Closer
One of the most significant upcoming changes is the full application of the Machinery Regulation (EU) 2023/1230 on 20 January 2027, replacing the Machinery Directive 2006/42/EC.
The change will affect manufacturers placing machinery on the EU market, including businesses supplying industrial equipment, automated systems, machinery assemblies and safety components.
Although much of the existing machinery safety framework remains familiar, the Regulation introduces changes to the legal requirements and conformity assessment framework. It also addresses areas such as safety-related software, artificial intelligence and cybersecurity where these affect machinery safety.
Manufacturers should not assume that existing technical documentation can simply be carried forward without review. Risk assessments, essential health and safety requirements, instructions, declarations and conformity assessment procedures should be checked against the new Regulation.
The key priority is preparation before 20 January 2027. Manufacturers should establish which requirements apply to their products, identify any gaps in their technical files and confirm the appropriate conformity assessment route.
Major Update to Harmonised Machinery Standards
A further development came with Commission Implementing Decision (EU) 2026/2015, published in September. The decision added 64 references to harmonised standards supporting the Machinery Directive, including updated standards relevant to industrial robotics.
These references can provide a presumption of conformity with the essential health and safety requirements covered by the relevant standards, provided the conditions of citation are met.
However, the timing is important. The current Machinery Directive standards list is due to be repealed when the new Machinery Regulation applies on 20 January 2027. A separate set of harmonised standards supporting the Regulation is being prepared.
Manufacturers should therefore check not only which standards currently apply, but also whether the standards they rely on will be cited under the new Regulation and whether any restrictions or additional requirements affect their use.
For businesses working with machinery, robotic systems and safety-related control systems, standards management should be an active part of the transition plan, rather than a last-minute documentation exercise.
Pressure Equipment Directive Standards Also Updated
October has also brought developments for manufacturers working under the Pressure Equipment Directive (PED) 2014/68/EU.
Commission Implementing Decision (EU) 2026/2211, published on 2 October 2026, updates the list of harmonised standards supporting the PED. The changes cover areas including refrigerating systems and heat pumps, LPG equipment, cryogenic vessels, and welding and brazing.
This is particularly relevant to manufacturers of pressure vessels, compressors, heat pumps, refrigeration equipment and associated pressure assemblies.
Businesses should review the standards cited for their specific equipment and confirm that the technical evidence supports the applicable essential safety requirements. Using a standard in isolation does not automatically demonstrate full PED compliance, particularly where equipment classification, materials, joining procedures, inspection or conformity assessment requirements also apply.
Digital CE Marking Under Consideration by the European Commission
A further headline emerged in October, as the European Commission considered the potential introduction of digital CE marking as part of its planned European Product Act.
The proposed reform is intended to modernise the EU’s wider product compliance framework, including standardisation, market surveillance and access to product information. Discussions have included the possibility of connecting conformity information with digital tools and the developing Digital Product Passport system.
For manufacturers, this could eventually mean easier access to declarations, product identification and supporting compliance information through digital channels. It could also help authorities verify product information and identify non-compliant goods more efficiently.
However, this remains a developing policy initiative, not a new legal obligation. The Commission has not announced that the existing CE marking symbol will be replaced, nor that manufacturers can stop applying physical markings where required. Businesses should continue to follow the legislation currently applicable to their products while monitoring the proposed reform.
CE marking is not simply the application of a logo. It is the outcome of a documented process demonstrating that a product meets the applicable legal requirements. Keeping that process current is essential to maintaining market access and managing product safety risks.